Configuring the RF Signal
R&S
®
SMBV100B
367User Manual 1178.4460.02 ─ 03
"Trapezoid"
1 = Trapezoid period
2 = Trapezoid rise
3 = Trapezoid fall
4 = Trapezoid high
Remote command:
[:SOURce<hw>]:LFOutput<ch>:SHAPe on page 844
Frequency
Sets the frequency of the LF generator for sine signals.
Set the signal shape with the parameter Shape.
Remote command:
[:SOURce]:LFOutput<ch>:FREQuency on page 840
Period
Sets the repetition rate of the generated LF signal for triangle, trapezoid or pulse
shapes, see Shape.
The period of sine signals is calculated from the selected Frequency
Remote command:
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRAPeze:PERiod on page 846
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRIangle:PERiod on page 846
[:SOURce<hw>]:LFOutput<ch>:SHAPe:PULSe:PERiod on page 844
Pulse Width
Sets the pulse duration of the generated pulse signal.
Remote command:
[:SOURce<hw>]:LFOutput<ch>:SHAPe:PULSe:WIDTh on page 845
Pulse Duty Cycle
Sets the ratio between the pulse duration and the pulse period in percent.
Remote command:
[:SOURce<hw>]:LFOutput<ch>:SHAPe:PULSe:DCYCle on page 844
Triangle Rise
Sets the time required for the triangle signal to change from low level to high level.
Remote command:
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRIangle:RISE on page 846
Analog Modulations
To Next Page
Loading...
