Configuring the Internal Baseband Source
R&S
®
SMBV100B
166User Manual 1178.4460.02 ─ 03
Use "Graphics > Graphic 1 (Complete)" view to retrieve more information on the gener-
ated signal.
The display confirms the expected EUTRA/LTE 10 MHz spectrum.
To transfer the generated file to the R&S SMBV100B
1. In the R&S WinIQSIM2, select "Transmission > Transmit".
2. In the "Waveform Transmission to Arbitrary Waveform Generator" dialog, select:
a) "Transmit from > Internal (WinIQSIM2)"
b) "Transmit to > Instrument".
c) Select "File" and define the filename the transmitted file is stored as.
d) Enable "Automatically Load and Start Waveform > On" and select the required
baseband, e.g. "Path A"
e) Add a comment to the waveform.
f) Select "Transmit".
Using the Arbitrary Waveform Generator (ARB)
To Next Page
Loading...
