Configuring the Internal Baseband Source
R&S
®
SMBV100B
170User Manual 1178.4460.02 ─ 03
● Place the symbol } at the end of the data set
The contents of the waveform file SICO.wv for 20 I/Q pairs is now ready for opera-
tion and reads:
{TYPE: SMU-WV,0}
{CLOCK: 10e6}
{LEVEL OFFS: 3.010300,0.000000}
{WAVEFORM-81:#I0Q0I1Q1...InQn}
Note: There is no readable representation for binary values in this document. This
is why we use the sequence I0Q0I1Q1...InQn to characterize the binary code in
the present example.
The following figure shows this waveform in a data editor.
Example: C-program for creating a waveform file
C-program SICO.cpp for creating the file SICO.txt containing 20 sine and cosine
pairs, converting them into binary data and creating the waveform file SICO.wv.
// SICO.cpp
// Defines the entry point for the console application
#include "stdafx.h"
#include <stdlib.h>
#include <stdio.h>
#include <math.h>
int _tmain(int argc, _TCHAR* argv[])
{
const unsigned int samples = 20;
const float pi = 3.141592654f;
int i;
// SICO.txt
// Creating the file SICO.txt containing 20 sine and cosine pairs
float grad, rad;
FILE *fp;
fp = fopen("SICO.txt", "w");
if (fp == 0)
Using the Arbitrary Waveform Generator (ARB)
To Next Page
Loading...
