Configuring the RF Signal
R&S
®
SMBV100B
313User Manual 1178.4460.02 ─ 03
The naming of the selection parameters in manual control (GUI) sometimes deviates
from the naming in the remote-control commands. In addition, the value names of the
selection parameters used in the signal generator partly differ from the SCPI syntax.
The instrument accepts all value names.
The correlation between the manual control and the corresponding remote control
commands, including the SCPI conform syntax are explained for each mode (see the
cross-reference tables).
See also the following programming examples on the sweep and list modes in remote
control:
●
Example "Setup an RF frequency or power sweep" on page 882
●
Example "Setup an LF sweep" on page 837
●
Example "Create an RF list and activate the list mode" on page 850
Auto mode (Sweep/List)
Figure 6-8: Auto mode (Sweep/List)
●
The instrument generates the signal continuously.
●
Trigger mode "Auto" is prerequisite (default). It causes the continuous generation
of the sweep signal.
●
Starts signal generation immediately with "State = On".
●
Switches automatically to the next step when the Dwell time has elapsed.
●
Stops signal generation with "State = Off".
Varying the RF Signal in List or Sweep Mode
To Next Page
Loading...
