Monitoring Signal Characteristics
R&S
®
SMBV100B
415User Manual 1178.4460.02 ─ 03
Figure 7-8: Graphics configuration dialog
2. To determine the kind of signal display, use the parameter "Mode".
3. To select suitable signal acquisition points, use the parameter "Source".
4. To enable the graphical signal display, select "Add".
A thumbnail of the graphical signal display is shown in the taskbar.
Figure 7-9: Graphics configuration dialog with active graphical signal displays
5. To enlarge the thumbnail, select it.
Settings:
Graphical Diagrams Table...........................................................................................416
Mode........................................................................................................................... 416
Source.........................................................................................................................416
Displaying Baseband Signal Characteristics in Real-Time
To Next Page
Loading...
