File and Data Management
R&S
®
SMBV100B
496User Manual 1178.4460.02 ─ 03
2. On the R&S SMBV100B, enable file transfer via SMB (samba).
3. Select "System Config > Setup > Remote Access > Network".
Select:
a) "Address Mode > Auto (DHCP)"
b) Check that the "DNS Suffix" and "DNS Server" are correct.
4. Press the [Save/Rcl] key.
5. In the "Save/Recall" dialog, select "File Manager > Map Network Share".
6. In the "Map Network Share" dialog, select:
a) In the "Network Folder" field, enter //<IP Address>/user or //
<Server Name>/user.
For example, //10.124.0.170/user.
b) In the "Local Folder" field, enter an alias name, e.g. setups.
c) Enter the "User Name" and "Password" of a user with a remote access permis-
sion to the selected network folder.
d) If necessary, enable "Reconnect at Startup".
e) Select "Connect".
The selected network folder is mapped to your instrument. The list of mapped net-
work folders is updated.
7. Close the "Map Network Share" dialog.
The navigation tree in the "File Manager" dialog displays the mapped network
folder as /shares/Setups.
Using the File Manager
To Next Page
Loading...
