Getting Started
R&S
®
SMBV100B
54User Manual 1178.4460.02 ─ 03
The minimum requirement for R&S SMBV100B in this example is a base unit equipped
with:
●
Option custom digital modulation R&S SMBVB-K520
●
Option frequency R&S SMBVB-B103.
The initial situation is not the instrument's preset state but rather the configuration
described in Chapter 2.3.1, "Generating an Unmodulated Carrier", on page 52.
1. In the block diagram, select "Baseband" and navigate to the section "Misc > Cus-
tom Digital Mod...".
The "Custom Digital Modulation" dialog opens.
2. In the "Custom Digital Modulation" dialog, select "General > Set according to Stan-
dard > WCDMA-3GPP".
3. Select "General > State > On" to enable signal generation.
Trying Out the Instrument
To Next Page
Loading...
