Rohde & Schwarz SMBV100B - Page 694

Remote Control Commands
R&S
®
SMBV100B
692User Manual 1178.4460.02 ─ 03
[:SOURce<hw>]:AM:DEViation:MODE............................................................................. 693
[:SOURce<hw>]:AM:RATio..............................................................................................694
[:SOURce<hw>]:AM<ch>:SENSitivity...............................................................................694
[:SOURce<hw>]:AM<ch>:STATe <State>
Activates amplitude modulation.
Suffix:
<ch>
.
1 to 2
Modulation signal channel
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Creating an amplitude modulated RF signal"
on page 690.
Manual operation: See "State" on page 352
[:SOURce<hw>]:AM<ch>:SOURce <Source>
Selects the modulation source for amplitude modulation.
Suffix:
<ch>
.
1 to 2
Modulation signal channel
Parameters:
<Source> EXT1 | NOISe | LF2 | LF1 | EXTernal | INTernal
LF1|LF2
Uses an internally generated LF signal.
EXT1
Uses an externally supplied LF signal.
NOISe
Uses the internally generated noise signal.
INTernal
Uses the internally generated signal of LF1.
EXTernal
Uses an external LF signal (EXT1).
Example:
See Example "Creating an amplitude modulated RF signal"
on page 690.
Manual operation: See "Source" on page 353
[:SOURce<hw>]:AM<ch>[:DEPTh] <Depth>
Sets the depth of the amplitude modulation in percent.
SOURce Subsystem