Rohde & Schwarz SMBV100B - Page 703

Remote Control Commands
R&S
®
SMBV100B
701User Manual 1178.4460.02 ─ 03
[:SOURce<hw>]:PM:DEViation:SUM................................................................................702
[:SOURce<hw>]:PM:RATio..............................................................................................703
[:SOURce<hw>]:PM:SENSitivity?.................................................................................... 703
[:SOURce]:PM<ch>[:DEViation].......................................................................................703
[:SOURce<hw>]:PM<ch>:STATe <State>
Activates phase modulation.
Activation of phase modulation deactivates frequency modulation.
Suffix:
PM<ch>
.
1|2
Sets the modulation signal channel.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Performing phase modulation" on page 699.
Manual operation: See "State" on page 352
[:SOURce<hw>]:PM<ch>:SOURce <Source>
Selects the modulation source for phase modulation signal.
Suffix:
PM<ch>
.
1|2
Sets the modulation signal channel.
Parameters:
<Source> EXT1 | NOISe | LF2 | LF1 | INTernal | EXTernal
LF1|LF2
Uses an internally generated LF signal.
EXT1
Uses an externally supplied LF signal.
NOISe
Uses the internally generated noise signal.
INTernal
Uses the internally generated signal of LF1.
EXTernal
Uses an external LF signal (EXT1).
Example:
See Example "Performing phase modulation" on page 699.
Manual operation: See "Source" on page 353
SOURce Subsystem