Rohde & Schwarz SMBV100B - Page 738

Remote Control Commands
R&S
®
SMBV100B
736User Manual 1178.4460.02 ─ 03
According to the specifications, the byte sequence is defined as 'most significant byte
first'.
The query reads out the data part of the list file. If the query is expanded by using the
two parameters <Start> and <Count>, the list is read out in smaller sections. With-
out the parameters the total length is always read out starting from address 1.
*RST has no effect on data lists.
Parameters:
<Data> integer
bit data
Query parameters:
<Start> integer
Range: 1 to 2147483647
<Count> integer
Range: 1 to 2147483647
Example: See Example "Performing general tasks" on page 712
[:SOURce<hw>]:BB:DM:DLISt:DATA:APPend <Bits>
Appends the bit data onto the end of the existing data in the selected data list. Existing
content in the data list is not overwritten. Hence, you can create long data lists piece-
meal.
The command cannot be used with an empty data list, like for example data lists that
has just been created. Use the command [:SOURce<hw>]:BB:DM:DLISt:DATA first
and enter modulation data in the list.
*RST has no effect on data lists.
Setting parameters:
<Bits> 0 | 1 {,0 | 1 } | block data
Example: See Example "Performing general tasks" on page 712
Usage: Setting only
[:SOURce<hw>]:BB:DM:CLISt:TAG?
[:SOURce<hw>]:BB:DM:DLISt:TAG?
Queries the content of the specified tag in the selected file.
Return values:
<Tag> <control list>,<tag name>
Refer to Chapter 3.6.5, "Tags for Waveforms, Data and Control
Lists", on page 177 for description of the available tag formats.
Example:
SOURce1:BB:DM:DLISt:TAG? "D_list","date"
Queries the Date tag in list D_list.
Usage: Query only
SOURce Subsystem