Remote Control Commands
R&S
®
SMBV100B
742User Manual 1178.4460.02 ─ 03
SOURce:BB:ARBitrary:STATe ON
// ******************************************************************
// Select the next segment trigger mode and source
// ******************************************************************
SOURce:BB:ARBitrary:TRIGger:SMODe NEXT
// SOURce:BB:ARBitrary:TRIGger:SMODe NSEam
SOURce:BB:ARBitrary:WSEGment:NEXT:SOURce INTernal
SOURce:BB:ARBitrary:WSEGment?
// 0
SOURce:BB:ARBitrary:WSEGment:NAME?
// "/var/user/ARB/multi_segment/Seg_0.wv"
// Seg_0 is output continuously
// ******************************************************************
// Trigger a switch over to the next segment
// ******************************************************************
SOURce:BB:ARBitrary:WSEGment:NEXT 3
// stops Seg_0 and starts immediatly Seg_3; Seg_3 is output continuously
SOURce:BB:ARBitrary:TRIGger:EXECute
//restarts Seg_3
SOURce:BB:ARBitrary:WSEGment:NEXT 2
SOURce:BB:ARBitrary:WSEGment:NEXT 0
// ******************************************************************
// Scrolling trough the segments, i.e. shwitch over in incremental order
// ******************************************************************
SOURce:BB:ARBitrary:WSEGment:NEXT:EXECute
SOURce:BB:ARBitrary:WSEGment?
// 1
SOURce:BB:ARBitrary:WSEGment:NEXT:EXECute
SOURce:BB:ARBitrary:WSEGment?
// 2
Refer to "To apply a manual segment switch to the output segments in the required
order" on page 216 for description of the steps necessary to achieve a similar task via
manual operation of the instrument.
Example: Using the ARB sequencer
The following example lists the commands necessary to configure a play list. The
example lists only the relevant commands.
We assume, that the multi-segment sequence ms_0to3 composed of four segments,
Seg_0, Seg_1, Seg_2 and Seg_3 is created and loaded in the ARB (see Exam-
ple "Creating a multi-segment waveform" on page 740). The required output order of
the segments is Seg_0, Seg_3 [2], Seg_2.
SOURce Subsystem
To Next Page
Loading...
