Scanlab RTC6 PCIe Board - Page 878

RTC6 boards
Doc. Rev. 1.0.21 en-US
16 Appendix A: The RTC6 Ethernet Board
878
innovators for industry
16.1.3 Options
Same as RTC6 PCIe Boards, see Chapter 2.6
”Options”, page 38. Additionally, with RTC6 Ethernet
Boards only:
• Option “LDSA”
– Support of Standalone Functionality by
laserDESK
Allows Standalone Functionality-related features
to be used in laserDESK.
Example: Booting an RTC6 Ethernet Board with a
Boot Image created under laserDESK.
Note that Boot Images created under laserDESK
cannot be used with RTC6 Ethernet Boards
without Option “LDSA”. For more information,
refer to the laserDESK online help.
See also get_rtc_version, Bit #11.
16.1.4 Labeling
Same as RTC6 PCIe Boards, see Chapter 2.1
”Labeling”, page 31.
16.1.5 Type Identification
Same as RTC6 PCIe Boards, see Chapter 2.7 ”Jumper
Settings and Type Designations”, page 40.
16.1.6 Unpacking Instructions and
Typical Scope of Delivery
Same as RTC6 PCIe Boards, see Chapter 2.2
”Unpacking Instructions and Typical Scope of
Delivery”, page 31.
16.1.7 Delivered Software
Same as RTC6 PCIe Boards, see Chapter 2.3
”Delivered RTC6 Software Package”, page 31.
16.1.8 Accessories for the RTC6 PCIe Board
Accessories mentioned in Chapter 2.8 ”Accessories
for the RTC6 PCIe Board”, page 44 for
RTC6 PCIe Board is (without suiting adapters) not
suitable for RTC6 Ethernet Boards (because of
different connector plugs and pitch of the pins).
16.1.9 Supplementary Software
As with RTC6 PCIe Boards, see Chapter 2.9
”Supplementary Software”, page 47.