Scanlab RTC6 PCIe Board - Page 985

RTC6 boards
Doc. Rev. 1.0.21 en-US
21 Appendix F: Change Index
985
innovators for industry
Changes to Document Revision 1.0.0 en-US from Document Revision 0.0
Changes to Document Revision 1.0.1 en-US from Document Revision 1.0.0 en-US
Where What
Global Initial Document-Revision.
Document Revision
• 1.0.0 en-US
applies to RTC6 Software Package
• V1.5.0
(a)
Appendix F: Change Index, page 984
(a) See also RTC6_Software_RevisionHistory_<Date>_<Rev>.pdf .
Where What
Global Document Revision
• 1.0.1 en-US
applies to RTC6 Software Package
• V1.5.2
(a)
eth_get_com_timeouts, page 364 Software change.
(a)
RTC6 DLL-only settings are now possible
even without access to an RTC6 Ethernet Board.
eth_set_com_timeouts, page 377 Same as eth_get_com_timeouts.
load_disk, page 498 Software change.
(a)
Has now a version control.
range_checking, page 575 Software change.
(a)
Mode = 2 added: a simulate_ext_stop is
passed on to all slave boards.
save_disk, page 600 Same as load_disk.
set_wobbel_vector, page 776 Editorial enhancement. To activate “Freely definable wobbel
shape” by set_wobbel_control and
set_wobbel_mode ( Mode = 3 ), see page 778.
sync_slaves, page 807 Software change.
(a)
Has no function anymore.
Appendix F: Change Index, page 984
(a) See also RTC6_Software_RevisionHistory_<Date>_<Rev>.pdf .