Scanlab RTC6 PCIe Board - Page 986

RTC6 boards
Doc. Rev. 1.0.21 en-US
21 Appendix F: Change Index
986
innovators for industry
Changes to Document Revision 1.0.2 en-US from Document Revision 1.0.1 en-US
Where What
Global Document Revision
• 1.0.2 en-US
applies to RTC6 Software Package
• V1.6.0
(a)
Section ”Folder iSCANCfg”, page 32 Software change.
(a)
iSCANcfg6.exe is replaced in the
RTC6 Software Package by the generic iSCANcfg.exe .
Chapter 7.4.1 ”Enabling, Activating and
Switching Laser Control Signals”
Editorial change. Figure 51, page 185.
control_command, page 346 Editorial change. Description of “PowerOK” and “TempOK”
has been changed, see XY2-100 status word. Furthermore,
the description of 0528
H
and 0529
H
has been removed from
the document (these data signal types are not intended for
users).
get_error, page 398 Editorial change. error bit Bit #15 no longer “reserved”, see
page 400.
Chapter 16.2.13 ”Master Socket Connector,
Slave Socket Connector”
Editorial change. New safety notice on Master/Slave-
connected RTC6 Ethernet Boards, see page 893.
Appendix F: Change Index, page 984
(a) See also RTC6_Software_RevisionHistory_<Date>_<Rev>.pdf .