Scanlab RTC6 PCIe Board - Page 991

RTC6 boards
Doc. Rev. 1.0.21 en-US
21 Appendix F: Change Index
991
innovators for industry
Changes to Document Revision 1.0.6 en-US from Document Revision 1.0.5 en-US
Changes to Document Revision 1.0.7 en-US from Document Revision 1.0.6 en-US
Where What
Global Document Revision
• 1.0.6 en-US
applies to RTC6 Software Package
• V1.7.6
(a)
Section ”Folder RTC6 Files”, page 33 Software change.
(a)
Other internal structure of the
RTC6 Software Package as well as more files.
get_startstop_info, page 426 Software change.
(a)
New Bit #15.
set_laser_delays, page 671 Editorial change. Default setting after load_program_file
corrected.
wait_for_encoder_mode, page 845 Editorial change. Allowed value range of Value corrected.
wait_for_encoder_in_range_mode,
page 844
Editorial change. Allowed value range of EncXmin corrected.
eth_configure_link_loss, page 357 Software change.
(a)
New command.
Chapter 16.5.4 ”Checking the Connection to
the RTC6 Ethernet Board”, page 906
Editorial enhancement.
Chapter 16.10.3 ”TI-RTOS”, page 923 Editorial enhancement. The RTC6 Ethernet Board uses
3rd party software.
Appendix F: Change Index, page 984
(a) See also RTC6_Software_RevisionHistory_<Date>_<Rev>.pdf .
Where What
Global Document Revision
• 1.0.7 en-US
applies to RTC6 Software Package
• V1.7.7
(a)
load_program_file, page 510 Editorial enhancement.
Chapter 18 ”Appendix C: The RTC6 EtherBox”,
page 932
Hardware change. Figure 93, Figure 94.
Appendix F: Change Index, page 984
(a) See also RTC6_Software_RevisionHistory_<Date>_<Rev>.pdf .