High-resolution timer (HRTIM) RM0440
1024/2126 RM0440 Rev 4
Bit 18 IDLEM2: Output 2 idle mode
This bit selects the output 2 idle mode.
0: No action: the output is not affected by the burst mode operation.
1: The output is in idle state when requested by the burst mode controller.
Note: This bit is preloaded and is changed during run-time, but must not be changed while the burst
mode is active.
Bit 17 POL2: Output 2 polarity
This bit selects the output 2 polarity.
0: Positive polarity (output active high)
1: Negative polarity (output active low)
Note: This parameter cannot be changed once the timer x is enabled.
Bits 16:15 Reserved, must be kept at reset value.
Bit 14 BIAR: Balanced Idle Automatic Resume
This bit selects is the outputs are automatically re-enabled after a balanced idle event.
This bit is only significant if DLYPRT[2:0] = 011 or 111, it is ignored otherwise.
0: Disabled
1: Enabled
Note: This parameter cannot be changed once the timer x is enabled.
Bit 13 Reserved, must be kept at reset value.
Bits 12:10 DLYPRT[2:0]: Delayed protection
These bits define the source and outputs on which the delayed protection schemes are applied.
In HRTIM_OUTAR, HRTIM_OUTBR, HRTIM_OUTCR:
000: Output 1 delayed idle on external event 6
001: Output 2 delayed idle on external event 6
010: Output 1 and output 2 delayed idle on external event 6
011: Balanced idle on external event 6
100: Output 1 delayed idle on external event 7
101: Output 2 delayed idle on external event 7
110: Output 1 and output 2 delayed idle on external event 7
111: Balanced idle on external event 7
In HRTIM_OUTDR, HRTIM_OUTER, HRTIM_OUTFR:
000: Output 1 delayed idle on external event 8
001: Output 2 delayed idle on external event 8
010: Output 1 and output 2 delayed idle on external event 8
011: Balanced idle on external event 8
100: Output 1 delayed idle on external event 9
101: Output 2 delayed idle on external event 9
110: Output 1 and output 2 delayed idle on external event 9
111: Balanced idle on external event 9
Note: This bitfield must not be modified once the delayed protection is enabled (DLYPRTEN bit set).
Bit 9 DLYPRTEN: Delayed protection enable
This bit enables the delayed protection scheme.
0: No action
1: Delayed protection is enabled, as per DLYPRT[2:0] bits
Note: This parameter cannot be changed once the timer x is enabled (TxEN bit set).
To Next Page
Loading...
Need help?
General
