Chapter 33 switch Commands
Management Switch Card User’s Guide
1005
This command displays the system’s GARP timer settings, including the join, leave and leave-all
timers. An example is shown next.
33.7.2 switch garptimer join Command
Syntax:
switch garptimer join <join msec>
where
This command sets the system’s join period timer for GVRP in milliseconds.
Switches join VLANs by making a declaration. A declaration is made by issuing a Join message
using GARP. GARP timers set declaration timeout values.
The following example sets the Join Timer to 300 milliseconds.
33.7.3 switch garptimer leave Command
Syntax:
switch garptimer leave <leave msec>
where
This command sets the system’s leave period timer for GVRP in milliseconds.
Switches join VLANs by making a declaration. Declarations are withdrawn by issuing a Leave
message. GARP timers set declaration timeout values.
The following example sets the Leave Timer to 800 milliseconds.
ras> switch garptimer show
join time (ms): 200
leave time (ms): 600
leaveall time (ms): 10000
ras>
<join msec> =
This sets the duration of the Join Period timer for GVRP in milliseconds. Each
port has a Join Period timer. The allowed Join Time range is between 100 and
32767 milliseconds; the default is 200 milliseconds.
ras> switch garptimer join 300
<leave msec> =
This sets the duration of the Leave Period timer for GVRP in milliseconds. Each
port has a single Leave Period timer. Leave Time must be two times larger than
Join Timer; the default is 600 milliseconds. The allowed Leave Time range is
between 201 and 65534 milliseconds; the default is 600 milliseconds.
ras> switch garptimer leave 800
To Next Page
Loading...
