ZyXEL Communications MSC1000G - Voip Sip Keypattern Show Command

Chapter 36 voip Commands
Management Switch Card User’s Guide
1091
36.15.4 voip sip keypattern show Command
Syntax:
voip sip keypattern show [name]
where
If a keypattern profile is not specified, this commands lists configured keypattern profiles. When a
profile is specified this command shows the settings of the specified profile, in this case the default
keypattern profile “DEFVAL”.
The following table describes the settings of a keypattern profile.
[name] =
The name of the keypattern profile (<=32 characters).
ras> voip sip keypattern show
KeyPattern Name(s):
----------------------
1. DEFVAL
2. keypattern1
ras> voip sip keypattern show DEFVAL
KeyPattern Name : DEFVAL
service type pattern
---------------- ----------------
callreturn *97#
calltransfer *98#
callwaitdisconn 1
callwaitoff #43#
callwaiton *43#
callwaitonhold 2
callwaitreject 0
clir ##
dndoff #99#
dndon *99#
callin #14
keyPattern name =
The name of the keypattern profile (<=32 characters).
service type =
This describes the feature configured in this keypattern profile.
pattern =
The pattern describes the telephone keys a user presses to access a
particular service. Characters are limited to the numerals 0~9, the pound
(#) and asterisk (*).
callreturn =
Enter the sequence of keys the user presses to dial the phone number of
the last incoming call (1~7 characters).
calltransfer =
Enter the sequence of keys the user presses to enable a call transfer (1~7
characters).
callwaitdisconn =
Enter the key the user presses to disconnect a current call and accept a
waiting call (one character only).
callwaitoff =
Enter the sequence of keys the user presses to turn call waiting off (1~7
characters).
callwaiton =
Enter the sequence of keys the user presses to enable call waiting (1~7
characters).