Chapter 9 Subscriber Port Setup Screens
Management Switch Card User’s Guide
311
9.32 Default
Click Port > Default in the navigation panel to open the screen shown next. Use this screen to
reset a subscriber port’s settings to the defaults.
Figure 203 Port > Default
The following table describes the fields in this screen.
9.33 PAEPVC
Click Port > PAEPVC in the navigation panel to open the screen shown next. Use this screen to
configure PPPoA-to-PPPoE translation PVC settings for individual ports.
Figure 204 Port > PAEPVC
Table 145 Port > Default
LABEL DESCRIPTION
Slot Select the number of a line card’s slot. The corresponding subscriber port setup screen for the
type of line card you selected automatically displays.
Port Select the number of a DSL port on the line card.
Apply Click Apply to reset the specified port’s settings to the defaults.
To Next Page
Loading...
