Chapter 6 Diagnostic Screens
Management Switch Card User’s Guide
169
The following table describes the labels in this screen.
6.6 The MLT Screen
Use this screen to perform a variety of standard Metallic Line Tests on the lines connected to VOP
ports. You can also allow or prohibit line tests using diagnostic equipment connected via the VOP’s
Test In and Test Out ports. Click Diagnostic > MLT. The following screen displays.
Figure 93 MLT (test mode)
Table 67 Trace Route
LABEL DESCRIPTION
Trace Route Type the IP address of a device.
Click Start to perform a trace route in order to check the path that packets take to get to the
IP address that you specified.
To Next Page
Loading...
