Chapter 13 Switch Screens
Management Switch Card User’s Guide
543
13.19.3 CFM Endpoint Screen: MIP
Click an MA index number in the Switch > CFM > CFM maintenance association screen and
then the MIP tab to display the screen shown next. Use this screen to configure Maintenance
association Intermediate Points (MIPs) under an MA.
Figure 375 CFM Endpoint: MIP
The following table describes the labels in this screen.
Port This field displays the end point’s physical port on the device.
Direction This field displays whether to send CCMs (Connectivity Check Messages) from the end
point you configured (down) or from (s) (up).
Priority This field displays the priority of the end point.
CCI-enabled This field displays the CCMs is sending for the configured end point or not.
Modify Select an end point and click Modify to bring the end point’s information shown in this
screen for modification.
Delete Select an end point and click Delete to remove it.
Table 288 CFM Endpoint: MEP (continued)
LABEL DESCRIPTION
Table 289 CFM Endpoint: MIP
LABEL DESCRIPTION
MD Name This displays the name of the MD for which you want to configure end points.
MA Name This displays the name of the MA for which you want to configure end points.
To Next Page
Loading...
