Chapter 13 Switch Screens
Management Switch Card User’s Guide
527
13.12 MSTP Setup
Use the MSTP screens to enable MSTP on the switch and configure MSTP bridge and port settings.
13.12.1 MSTP Bridge Settings
Click Switch > MSTP in the navigation panel to display the screen shown next. Use this screen to
configure MSTP and RSTP settings.
Figure 361 MSTP: Bridge
The following table describes the labels in this screen.
Table 279 MSTP: Bridge
LABEL DESCRIPTION
Config Name Enter a descriptive name (up to 31 characters) of an MST region.
Revision
Level
Enter a number to identify a region’s configuration. Devices must have the same revision level
to belong to the same region.
To Next Page
Loading...
