ZyXEL Communications MSC1000G - Switch Queuemap Commands

Chapter 33 switch Commands
Management Switch Card User’s Guide
1030
33.17 switch queuemap Commands
Use these commands to set the priorities of the individual queues.
33.17.1 switch queuemap set Command
Syntax:
switch queuemap set <priority> <queue>
where
This command sets the system to use a particular queue for traffic of a specific IEEE 802.1p
priority.
The following example sets the system to use queue 3 for traffic with priority 3.
33.17.2 switch queuemap show Command
Syntax:
switch queuemap show
This command shows which queue the system uses for traffic of each priority. The following is an
example.
<priority>
=
The IEEE 802.1p priority for each queue, 0~7.
<queue>
=
A physical queue in the system, 0~7.
ras> switch queuemap set 3 3
ras> switch queuemap show
priority queue
-------- -----
0 2
1 0
2 1
3 3
4 4
5 5
6 6
7 7
ras>