ZyXEL Communications MSC1000G - Port Ppvc Member Delete Command

Chapter 29 port Commands
Management Switch Card User’s Guide
811
This command removes a PPVC. Removing a PPVC also deletes all of the member PVCs.
The following example removes a PPVC with VPI 8 and VCI 35 for port 5 on the line card in slot 7.
29.28.2 port ppvc member delete Command
Syntax:
port ppvc member delete <slot-port-vpi/vci> <vpi/vci>
where
This command removes a PVC channel from PPVC group.
The following example removes a PVC that uses VPI 8 and VCI 36 from a PPVC with VPI 8 and VCI
35 for port 5 on the line card in slot 7.
29.28.3 port ppvc member set Command
Syntax:
port ppvc member set <slot-port-vpi/vci> <vpi/vci> <atmprofile> <level>
where
This command adds a member PVC to a PPVC. You must create the PPVC before you use this
command to add a member.
The following example adds a PVC to a PPVC with VPI 8 and VCI 35 for port 5 on the line card in slot
7. The PVC uses VPI 8 and VCI 36, the DEFVAL ATM profile and priority queue 2.
ras> port ppvc delete 7-5-8/35
<slot-port-
vpi/vci>
=
The slot and port(s) and VPI/VCI of the PPVC.
<vpi/vci>
=
The VPI and VCI of the individual PVC that you are removing from the PPVC.
ras> port ppvc member delete 7-5-8/35 8/36
<slot-port-
vpi/vci>
=
The slot and port(s) and VPI/VCI of the PPVC.
<vpi/vci>
=
The VPI and VCI of the individual PVC that you are adding to the PPVC. The
VPI setting can be 0 to 255. The VCI setting can be 32 to 65535 with a VPI of 0
or 1 to 65535 if the VPI is not 0.
<atmprofile>
=
The name of an ATM profile.
<level>
=
The priority queue (0~3) to use for this PVC’s traffic. 3 is the highest priority.
ras> port ppvc member set 7-5-8/35 8/36 DEFVAL 2