Chapter 9 Subscriber Port Setup Screens
Management Switch Card User’s Guide
307
9.30.1 E1 Port Setup Line Card Screen
Click Port > E1 in the navigation panel to open the E1 Port Setup screen. Click an active IMA line
card’s ID number to open the following screen. Use this screen to enable/disable or configure E1
ports on the line card.
Figure 200 E1 Port Setup: Line Card
The following table describes the fields in this screen.
Up Time This field displays how long the line card has been running since the last time it was started.
Firmware This field displays the current firmware version installed on the line card.
Table 141 E1 Port Setup (continued)
LABEL DESCRIPTION
Table 142 E1 Port Setup: Line Card
LABEL DESCRIPTION
UP Click this to return to the previous screen.
Copy Select a port in the Select column and then do the following to copy the settings from the port
to another port or ports.
1. Click Copy.
2. Select to which IMA line card you want to copy the settings.
3. Select to which ports on the line card you want to copy the settings. Use Select All to
select every port. Use Select None to clear all of the check boxes.
4. Click Apply to paste the settings.
To Next Page
Loading...
