ZyXEL Communications MSC1000G - Multicast Smcast Commands

Chapter 28 multicast Commands
Management Switch Card User’s Guide
752
This command displays the current multicast VLAN settings. In the state column, “-” indicates the
multicast VLAN is not active while “V” indicates the multicast VLAN is active.
28.12 multicast smcast Commands
Use the following multicast commands to manage static multicast groups.
28.12.1 multicast smcast delete Command
Syntax:
multicast smcast delete <vid> <group-ip>
where
This command removes a static multicast group entry.
The following example removes a static multicast group for VLAN 23 with static multicast address
239.255.255.255.
28.12.2 multicast smcast set Command
Syntax:
multicast smcast set <vid> <group-ip> all|sub1|sub2|up1|up2|<slot-port>
fix|forbid|normal
where
ras> multicast mvlan show
idx vid state name
--- ---- ----- -------------------------------
1 10 V example
2 12 -
ras>
<group-ip> =
A multicast IP address.
ras> multicast smcast delete 23 239.255.255.255
<group-ip> =
A multicast IP address.
all|sub1|sub2|up1
|up2|<slot-port>
=
The port or ports to which this static multicast group is to apply.