Chapter 29 port Commands
Management Switch Card User’s Guide
825
This command sets the second VLAN tag to add to the packets from the PVC.
The following example adds a VLAN tag (100) to the traffic using the DEFVAL ATM profile on PVC
(
1/33) on port 2 of the line card in slot 3.
29.40.3 port tlspvc show Command
Syntax:
port tlspvc show <slot>|<slot-port>|<slot-port-vpi/vci>
This command displays the TLS settings for the specified slot/port/PVC.
29.41 port vdsl Commands
Use the port vdsl commands to configure the subscriber VDSL ports.
29.41.1 port vdsl alarmprof Command
Syntax:
port vdsl alarmprof <slot-port> <profile>
This command sets the VDSL port(s) to use the specified alarm profile.
29.41.2 port vdsl compatible Command
Syntax:
port vdsl compatible <slot-port> none|adsl2|adsl2+
where
<vid>
=
The VLAN ID the switch adds to the traffic on the PVC. This is the VLAN ID known
in the service provider’s network.
Note: Make sure this VLAN ID is not already used for MVLAN or PAE.
ras> port tlspvc set 3-2-1/33 DEFVAL llc 100 12
ras> port tlspvc show 3-2
pvc type mux pvid pri profile
-------------- ------- ----- ------ ---- -------------------
3-2-1/33 tls llc 100 1 DEFVAL
ras>
none
=
Has the VDSL2 services use their normal frequency band plan.
adsl2
=
Has the VDSL2 services not use the ADSL2 frequency bands to avoid possible interference
with ADSL2 services provided by another device on the same bundle of lines.
To Next Page
Loading...
