Chapter 8 Multicast Screens
Management Switch Card User’s Guide
201
Figure 122 MVLAN Port Setting
The following table describes the labels in this screen.
8.9 MVLAN Group Setup Screen
Click Multicast > MVLAN in the navigation panel to display the MVLAN configuration screen. Click
a MVLAN’s VID to open the following screen where you can edit the multicast group that the MVLAN
uses.
Table 84 MVLAN Port Setting
LABEL DESCRIPTION
1~X The numbers represent the individual ports on the card.
Use the F, -, and X radio buttons to set each port’s membership in the MVLAN.
Select F to make the port a permanent member of the MVLAN.
Select - to make the port a normal member and allow it to join the MVLAN dynamically.
Select X to set the port to “forbidden” meaning it is always blocked from joining the MVLAN.
Use the All Fix, All Normal or All Forbidden button if you want to set all of the card’s ports to
the same membership status for this MVLAN.
Apply Click Apply to save the changes in this screen to the system’s volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile memory
when you are done configuring.
Cancel Click Cancel to close the screen without saving your changes.
To Next Page
Loading...
