Management Switch Card User’s Guide 755
CHAPTER 29
port Commands
This chapter shows you how to use the port commands.
29.1 General port Command Parameters
The following table describes commonly used port command parameter notation.
29.2 port Commands Summary
The following table lists the port commands. The P column on the right indicates the administrator
privilege level needed to use the command.
Table 363 General port Command Parameters
NOTATION DESCRIPTION
alarmprofile
The name of an alarm profile configured using the profile alarm commands.
registration
Specify whether a port joins (join) or leaves (leave) a VLAN.
tag
The VLAN tag. Options are tag or untag.
slot-port-vpi/vci
The card inserted in a slot, a port on that line card, and the VPI/VCI settings for the
DSL line connected to that port, for example: 3-1-0/33, 3-1~10-0/33, 3-*-0/33, *-
*-0/33
slot-port
A line card inserted in a slot and a port on that card. For example, 3-1, *-*, 3-* or
3~5,10~15.
option_mask
This is used to configure DSL connection settings.
Option bit map, 0x0000~0x0400.
0x0001: disables Trellis coding in ADSL mode
0x0002: disables Reed-Solomon coding for ADSL
0x0004: disables upstream 1-bit constellation support
0x0008: disables downstream bitswap
0x0010: disables 1-bit constellation
0x0020: disables the transmit windowing in ADSL2+ mode
0x0040: disables S=0.5 support in G.dmt.
0x0080: disables G.lite rate limit (G.lite only)
0x0100 - disables the nitro mode
To Next Page
Loading...
