ZyXEL Communications MSC1000G - Voip Sip Prack Command

Chapter 36 voip Commands
Management Switch Card User’s Guide
1093
36.17 voip sip prack Command
Use these commands to enable, disable, or show the 100rel request of the VoIP SIP line cards.
36.17.1 voip sip prack disable Command
Syntax:
voip sip prack disable
This command disables the 100rel request of the VoIP SIP line cards.
36.17.2 voip sip prack enable Command
Syntax:
voip sip prack enable
This command enables the 100rel request of the VoIP SIP line cards.
36.17.3 voip sip prack show Command
Syntax:
voip sip prack show
This command displays the PRACK configuration of the VoIP SIP line cards.
36.18 voip sip regcount Command
Use these commands to configure or show the SIP service’s registration count per second.
36.18.1 voip sip regcount set Command
Syntax:
voip sip regcount off|{on <regcount>}
where
This command configures the SIP service’s registration count per second.
36.18.2 voip sip regcount show Command
Syntax:
voip sip regcount show
This command displays the SIP service’s registration count per second.
<regcount> =
This is the registration count per second (5~30).