ZyXEL Communications MSC1000G - Loop Guard Setup

Chapter 4 Access Control List Screens
Management Switch Card User’s Guide
125
Figure 61 Loop Guard - Network Loop
Note: After resolving the loop problem on your network you can re-activate the disabled
port via the Web Configurator or via commands.
4.21 Loop Guard Setup
Click ACL > Loop Guard in the navigation panel to display the screen as shown.
Note: The loop guard feature cannot be enabled on ports that have Spanning Tree
Protocol (RSTP or MSTP) enabled.
Figure 62 ACL > Loop Guard
A
1
P
P
BC