ZyXEL Communications MSC1000G - Profile Ratelimit Delete Command

Chapter 30 profile Commands
Management Switch Card User’s Guide
887
30.15.1 profile ratelimit delete Command
Syntax:
profile ratelimit delete <profile>
This command removes the specified Ethernet subscriber port rate limit profile.
Note: You cannot remove a rate limit profile that is currently in use.
30.15.2 profile ratelimit map Command
Syntax:
profile ratelimit map <profile>
This command displays the Ethernet subscriber port(s) to which the specified rate limit profile is
applied.
The following example displays the port mapping table for the
DEFVAL rate limit profile.
30.15.3 profile ratelimit set Command
Syntax:
profile ratelimit set <profile> <ingress-rate> <egress-rate>
where:
This command configures an Ethernet subscriber line ingress and egress rate profile.
ras> profile ratelimit map DEFVAL
slot port
---- ------------------------------------------------------------------------
1 2 3 4 5 6 7
123456789012345678901234567890123456789012345678901234567890123456789012
3
4 ------------------------------------------------
5 ------------------------------------------------
6 ------------------------------------------------
7 VVVVVVVVVVVVVVVVVVVV
8 VVVVVVVVVVVVVVVVVVVV
9 ------------------------
10 ------------------------
<ingress-
rate>
=
The maximum allowed aggregate data transfer rate (in Kbps) for traffic coming in
from the subscriber. 0~99968 in kbps in steps of 64 Kbps. 0 means no limit.
<egress-
rate>
= The maximum allowed aggregate data transfer rate (in Kbps) for traffic coming going
to the subscriber. 0~99968 in Kbps in steps of 64 Kbps. 0 means no limit.