ZyXEL Communications MSC1000G - Profile Vdsl2 Lineprofile Set Command

Chapter 30 profile Commands
Management Switch Card User’s Guide
894
30.18.1 profile vdsl2 lineprofile set Command
Syntax:
profile vdsl2 lineprofile set <profile> [ramodeds manual|rainit|dynamicra|sos]
[ramodeus manual|rainit|dynamicra|sos]
[rausnrmds <up_shift_nrm_ds>]
[rausnrmus <up_shift_nrm_us>]
[raustimeds <up_shift_time>]
[raustimeus <up_shift_time>]
[radsnrmds <down_shift_nrm_ds>]
[radsnrmus <down_shift_nrm_us>]
[radstimeds <down_shift_time>]
[radstimeus <down_shift_time>]
[targetsnrmds <target_margin_ds>]
[targetsnrmus <target_margin_us>]
[maxsnrmds <max_margin_ds>]
[maxsnrmus <max_margin_us>]
[minsnrmds <min_margin_ds>]
[minsnrmus <min_margin_us>]
[msgminds <msgmin>]
[msgminus <msgmin>]
[maxnomatpds <tx_power>]
[maxnomatpus <tx_power>]
[maxaggrxpwrus <rx_power>]
[rfiband <start_tone> <end_tone> [...]]
[bitswapds disable|enable]
[bitswapus disable|enable]
[snrmodeds disable|enable]
[snrmodeus disable|enable]
[refvnds <tone_index> <vn_psd> [...]]
[refvnus <tone_index> <vn_psd> [...]]
[dpbotype <dpbotype>]
[dpboescma <escma>][dpboescmb <escmb>][dpboescmc <escmc>]
[dpboesel <esel>][dpboeselmin <eselmin>]
[dpbomus <mus>][dpbofmax <fmax>][dpbofmin <fmin>]
[dpboepsd <tone> <epsd> [...]|<psdid>]
[upbokl <esel>][upboklf <disable|auto|override>]
[upbopsda <us1a~us4a>][upbopsdb <us1b~us4b>]]
[vdsl2profile <vdsl2_profile_list>]
[limitmask d32|d48|d64|d128|b7-1~10|b8-1~16]
[us0band disable|enable]
[us0mask eu32|eu36|eu40|eu44|eu48|eu52|eu56|eu60|eu64|eu128]
[psdmaskds <psd_index> <psd> [...]]
[psdmaskus <psd_index> <psd> [...]]
[sostimeds <sos_time>]
[sostimeus <sos_time>]
[soscrcds <sos_crc>]
[soscrcus <sos_crc>]
[sosntoneds <sos_ntone>]
[sosntoneus <sos_ntone>]
[sosmaxds <sos_max>]
[sosmaxus <sos_max>]
[rocsnrmds <roc_snrm>]
[rocsnrmus <roc_snrm>]
[rocmininpds <roc_mininp>]
[rocmininpus <roc_mininp>]
[rocenableds disable|enable]