ZyXEL Communications MSC1000G - Switch Mstp Cfgname Command

Chapter 33 switch Commands
Management Switch Card User’s Guide
1015
33.12.1 switch mstp cfgname Command
Syntax:
switch mstp cfgname <config name>
where
This command sets the switch to belong to the specified MST region.
The following example sets the switch to be a member of the test MST region.
33.12.2 switch mstp disable Command
Syntax:
switch mstp disable
This command deactivates the MSTP feature on the switch.
33.12.3 switch mstp enable Command
Syntax:
switch mstp enable
This command activates the MSTP feature on the system.
33.12.4 switch mstp fwdelay Command
Syntax:
switch mstp fwdelay <fwdelay-sec>
This command sets the forward delay period (between 4 and 30 seconds) the switch waits before
changing states.
The following example sets the forward delay time to 15 seconds.
33.12.5 switch mstp hellotime Command
Syntax:
switch mstp hellotime <hellotime-sec>
<config name> =
A unique name (up to 31 characters) that identifies an MST region.
ras> switch mstp cfgname test
ras> switch mstp fwdelay 15