ZyXEL Communications MSC1000G - The DTPVC Setup Slot Screen

Chapter 10 IMA Screens
Management Switch Card User’s Guide
324
10.6.1 The DTPVC Setup Slot Screen
Click IMA > DTPVC in the navigation panel to open the DTPVC Setup screen. Click an active IMA
line card’s ID number to open the following screen. Use this screen to view and delete DTPVCs on
IMA groups of the line card.
Figure 213 IMA > DTPVC Setup: Slot
The following table describes the fields in this screen.
State This field displays the line card’s current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could be due to
the card starting, a firmware upgrade in progress or a malfunction. See Section 38.7 on page
1111 for what to do if the line card stays stuck in the inactive state.
Card Type This field displays the type of a line card.
Up Time This field displays how long the line card has been running since the last time it was started.
Firmware This field displays the current firmware version installed on the line card.
Table 151 DTPVC Setup (continued)
LABEL DESCRIPTION
Table 152 IMA > DTPVC Setup: Slot
LABEL DESCRIPTION
UP Click this to return to the previous screen.
Delete Click Delete to remove the selected DTPVC(s).
Previous 10 Click Previous 10 to show the preceding 10 pages of information.
Previous Click Previous to show the preceding screen if the information cannot be displayed in one
screen.
Page X of X This identifies which page of information is displayed and the total number of pages of
information.
Next Click Next to show the following screen if the information cannot be displayed in one screen.
Next 10 Click Next 10 to show the following 10 pages of alarms.
Index This is the number of the DTPVC.
Group This is the number of an IMA group on the line card.
VPI/VCI This field displays the Virtual Path Identifier (VPI) and Virtual Circuit Identifier (VCI). The VPI
and VCI identify a channel on this group.
Profile This field displays the ATM profile that this channel uses.