Chapter 29 port Commands
Management Switch Card User’s Guide
794
This command deletes the specified gbond group. The following is an example.
29.12 Port h248 Commands
Use these commands to configure the H.248 ports.
29.13 port h248 set Command
Syntax:
port h248 set <slot-port> <dsp_profile>
This command sets which DSP (Digital Sound Processing) profile the specified H.248 ports use.
The following example sets ports 1~24 on the VOP card in slot 3 to use the DEFVAL DSP profile.
29.14 port h248 termination Command
Syntax:
port h248 termination <slot-port> <name> [<step>]
where
This command creates terminations for H.248 ports. The termination name can be up to 32
characters.
The following example sets ports 1~24 on the VOP card in slot 3 to use termination names
A301~A324.
ras> port gbond delete 2 group2
ras> port gbond show 2
slot bond name
port list
---- ----------------------------------------
2 Group1
1,2
ras> port h248 set 3-1~24 DEFVAL
step
=
When creating multiple terminations, enter the interval between names (-10000~10000).
For example, enter “1~10” for the ports and “1” for the step to increment each
termination name by one.
ras> port h248 termination 3-1~24 A301 1
To Next Page
Loading...
