Chapter 13 Switch Screens
Management Switch Card User’s Guide
544
13.19.4 CFM Endpoint: MIP Slot Screen
In the CFM Endpoint: MIP screen, click the ID of a line card to display the screen shown next. This
screen lists the MIP setting for each of the line card’s ports.
MSC1000G Select Enable and specify a MAC address to set a MIP on an MSC port.
Apply Click Apply to save the changes in this section to the system’s volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save link
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
Slot
Port
Use the drop-down list boxes to select a DSL port on a line card for which you want to
configure MIP settings.
Load Click Load to display the port’s current settings.
Enable Select Enable and specify a MAC address to set a MIP on a DSL port.
Apply Click Apply to save the changes in this section to the system’s volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save link
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields.
ID This is the slot number of a line card. Click the index number of an active line card to
display a screen that lists the MIP setting for each of the line card’s ports.
State This field displays the line card’s current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could be due
to the card starting, a firmware upgrade in progress or a malfunction. See Section 38.7
on page 1111 for what to do if the line card stays stuck in the inactive state.
Card Type This field displays the type of a line card.
Up Time This field displays how long the line card has been running since the last time it was
started.
Firmware This field displays the current firmware version installed on the line card.
Table 289 CFM Endpoint: MIP (continued)
LABEL DESCRIPTION
To Next Page
Loading...
