ZyXEL Communications MSC1000G - Port Gbond Set Command

Chapter 29 port Commands
Management Switch Card User’s Guide
793
29.11.1 port gbond set Command
Syntax:
port gbond set <slot> <bond_name> <portlist>
where
This command sets up a gbond group on the specified group of ports on a slot. The following is an
example.
29.11.2 port gbond show Command
Syntax:
port gbond show <slot> [<bond_name>]
where
This command displays gbond settings on the specified group of ports on a slot. The following is an
example.
29.11.3 port gbond delete Command
Syntax:
port gbond delete <slot> <bond_name>
where
<slot>=
The line card ID.
<bond_name>=
A descriptive name for the gbond group of DSL lines.
<portlist>=
The ports on a line card that connect the DSL lines on which gbond is configured.
ras> port gbond set 2 group2 3,4
<slot>=
The line card ID.
<bond_name>=
A descriptive name for the gbond group of DSL lines.
ras> port gbond show 2
slot bond name
port list
---- ------------------------------------
2 Group1
1,2
2 group2
3,4
<slot>=
The line card ID.
<bond_name>=
A descriptive name for the gbond group of DSL lines.