Chapter 29 port Commands
Management Switch Card User’s Guide
775
29.3 port Commands
Use the port commands to configure the line card ports.
29.4 port adsl Commands
Use the port adsl commands to configure the subscriber ADSL ports.
qschedule <slot-port> [<spq> |
<wrr <wt0> <wt1>
<wt2> <wt3> <wt4>
<wt5> <wt6> <wt7>>]
Sets the port’s Class of Service (CoS) scheduling
method. SPQ (Strict Priority Queuing) services
queues based on the traffic’s IEEE 802.1p priority.
WRR (Weighted Round Robin) gives queues with
larger weights more service. wt0 - wt7 set the
priority weight (0~15) of each IEEE 802.1p priority
queue.
8
ratelimit <slot-port> <rate-
limit_profile>
Sets the specified port(s) to use a profile of egress
and ingress rate settings.
8
set <slot-port>
<template>
Sets the specified port(s) to use a VDSL2 template
profile.
8
tls disable <slot-port>
Disables Transparent LAN Service (TLS). The
system does not insert additional VLAN tags to
packets.
8
enable <slot-port>
Turns on Transparent LAN Service (TLS) to insert
additional VLAN tags to packets.
8
set <slot-port>
<svid> <spriority>
[prio_copy]
Sets/changes TLS settings on the VDSL port(s).
svid: The service provider VLAN ID.
spriority: The service provider IEEE 802.1p
priority setting.
prio_copy:
0- leave the service provider tag’s priority level
blank.
1- use the customer tag’s priority as the service
provider tag’s priority.
8
vlan <slot-port> <vid>
<registration> <tag>
Sets the VLAN setting on the VDSL port(s). 8
xvlan delete <slot-port>
<cvid>
Removes the specified XVLAN entry (cvid) from the
specified port.
8
set <slot-port>
<cvid> <svid>
Creates an XVLAN entry for the specified port.
cvid is the original customer VLAN ID. When the
port receives traffic from the subscriber with a
cvid VLAN tag, XVLAN changes it to the svid
before forwarding it to the service provider’s
network.
8
show <slot-port>
Displays the XVLAN settings for the specified port. 8
Table 364 port Commands (continued)
COMMAND DESCRIPTION P
To Next Page
Loading...
