ZyXEL Communications MSC1000G - Switch Port Name Command

Chapter 33 switch Commands
Management Switch Card User’s Guide
1026
33.14.8.7 switch port mstp show Command
Syntax:
switch port mstp show <mstid> [<end_mstid>]
This command displays the specified MSTP’s settings on each Gigabit Ethernet interface. The
following example displays the port MSTP setting for spanning tree 10.
33.14.9 switch port name Command
Syntax:
switch port name <giga-port> <name>
where
This command sets the name of a Gigabit Ethernet interface.
The following example sets the name of uplink interface 1 to
xyz.
33.14.10 switch port priority Command
Syntax:
switch port priority <giga-port> <priority>
where
This command sets the default ingress user priority of a Gigabit Ethernet interface.
The following example sets the default priority of uplink interface 1 to 3.
ras> switch port mstp show 10
[msti 10]
port en prio pathcost
---- ---- ---- ---------
sub1 - 128 0
sub2 - 128 0
up1 V 128 16
up2 - 128 0
<name> = A name to identify the port.
ras> switch port name up1 xyz
<priority> =
The default ingress priority (0~7).
ras> switch port priority up1 3