ZyXEL Communications MSC1000G - Sys Client6 Commands

Chapter 34 sys Commands
Management Switch Card User’s Guide
1041
An example is shown next. A “V” in a column means that the secured client set is activated or the
services can be used for managing the system.
34.3.8 sys client6 Commands
Use the sys client6 commands to configure IPv6 address ranges of trusted computers that may
manage the the IES and the services that they can use.
ras> sys client show
secured client:
idx enable start ip end ip telnet ftp web icmp ssh snmp https
--- ------ --------------- --------------- ------ --- --- ---- --- ---- -----
1 yes 0.0.0.0 0.0.0.0 V V V V V V -
2 no 0.0.0.0 0.0.0.0 - - - - - - -
3 no 0.0.0.0 0.0.0.0 - - - - - - -
4 no 0.0.0.0 0.0.0.0 - - - - - - -
5 no 0.0.0.0 0.0.0.0 - - - - - - -
6 no 0.0.0.0 0.0.0.0 - - - - - - -
7 no 0.0.0.0 0.0.0.0 - - - - - - -
8 no 0.0.0.0 0.0.0.0 - - - - - - -
9 no 0.0.0.0 0.0.0.0 - - - - - - -
10 no 0.0.0.0 0.0.0.0 - - - - - - -
11 no 0.0.0.0 0.0.0.0 - - - - - - -
12 no 0.0.0.0 0.0.0.0 - - - - - - -
13 no 0.0.0.0 0.0.0.0 - - - - - - -
14 no 0.0.0.0 0.0.0.0 - - - - - - -
15 no 0.0.0.0 0.0.0.0 - - - - - - -
16 no 0.0.0.0 0.0.0.0 - - - - - - -