ZyXEL Communications MSC1000G - Show Ipbpvc Route Command

Chapter 32 show Commands
Management Switch Card User’s Guide
958
This command displays the (run-time) downlink interfaces for the selected range of IP addresses
and/or VLAN. This table includes all the forwarding information for downstream traffic, whether
learned by snooping DHCP packets or provided manually.
An example is shown next.
32.3.22 show ipbpvc route Command
Syntax:
show ipbpvc route [<domain-name>|<ip/mask>|<domain-name> <ip/mask>]
where
This command displays the (run-time) routing table(s) for the selected domain or range of IP
addresses. This table includes all the entries, whether added automatically by the system or
provided manually.
An example is shown next.
The type field indicates whether this entry is used for upstream traffic (U, or uplink interface) or
downstream traffic (D, or downlink interface). By default, all entries are for downstream traffic,
unless the Edge Router IP is configured in the edge router commands (see Section 29.20 on page
800).
The other output values correspond to the input values of other IP bridge routing table commands.
32.3.23 show lineinfo Command
Syntax:
show lineinfo <slot-port> [data|pots]
This command shows the line operating values and status of a port.
ras> show ipbpvc interface
ip/mask vid slot port vpi vci
------------------ ---- ---- ---- --- ----
192.168.3.0/24 402 - - - -
<domain-name>=
The domain name, up to 31 characters.
<ip/mask>=
The interface IP and the subnet mask length.
ras> show ipbpvc route
domain ip/mask nexthop mtrc pr type
------------------------------- ------------------ --------------- ---- -- ---
ISP1 0.0.0.0/0 123.23.19.254 15 0 U
ISP1 123.23.19.249/32 - - - U
ISP1 123.23.19.254/32 - - - U
ISP1 192.169.1.0/24 123.23.19.249 5 0 U
example 192.168.1.200/32 - - - U