ZyXEL Communications MSC1000G - Switch Commands

Management Switch Card User’s Guide 983
CHAPTER 33
switch Commands
This chapter shows you how to use the switch commands.
33.1 switch Commands Overview
The switch commands configure switching functions and manage the Ethernet interfaces.
33.2 General switch Command Parameters
The following table describes commonly used switch command parameter notation.
33.3 switch Commands Summary
The following table lists the switch commands. The P column on the right indicates the
administrator privilege level needed to use the command.
Table 385 General switch Command Parameters
NOTATION DESCRIPTION
profile
The profile name configured in profile switch (<=32 characters).
ma-name:
A maintenance association name (<=32 characters).
md-name
The name of a maintenance domain (<= 32 characters).
mep-id
The maintenance association end point identifier (1~8191).
giga-port
One or all Ethernet ports, enet1|enet2|enet3|enet4|enet5|enet6|all.
Table 386 switch Commands
COMMAND DESCRIPTION P
switch bandwidth disable <giga-port>
Turns off bandwidth control on the specified
port(s).
8
enable <giga-port>
Turns on bandwidth control on the specified
port(s).
8
set <giga-port>
<ingress-rate>
<egress-rate>
Sets the incoming or outgoing bandwidth control
for the specified Gigabit port(s) (0~1000 Mbps).
ingress-rate: The incoming bandwidth rate on a
port.
egress-rate: The outgoing bandwidth rate on a
port.
8