Chapter 19 acl Commands
Management Switch Card User’s Guide
679
This command displays PPPoE line information settings. The following figure shows the PPPoE agent
setting for VLAN 10.
19.16 acl rule Commands
Use the acl rule commands to apply ACL profiles (you created using the profile acl
commands) on the PVCs.
19.16.1 acl rule delete Command
Syntax:
acl rule delete <slot-port-vpi/vci> <profile>
where
This command allows you to remove an access control setting from the specified PVC.
19.16.2 acl rule nomatch Command
Syntax:
acl rule nomatch <slot-port> accept|deny
This command allows you to select whether to forward (accept) or drop (deny) traffic that does not
match any of the rules in the ACL profile. This only applies to the VLC13XXG and the ELC.
The following example drops traffic on slot 6 port 3 that does not match any of the rules in the ACL
profile.
19.16.3 acl rule set Command
Syntax:
acl rule set <slot-port-vpi/vci> <profile>
ras> acl pppoeagent show
vid en info
---- ----- ------------------------
10 V testing
vlan set: 1
ras>
<profile>
=
Name of an access control profile.
ras> acl rule nomatch 6-3 deny
To Next Page
Loading...
