Chapter 7 Maintenance Screens
Management Switch Card User’s Guide
183
Figure 107 Reboot
Use the Config Save screen first if you want to save the system’s current configuration. Otherwise,
using the Reboot button will return the system to the configuration that was last saved to
nonvolatile memory.
Click the Reboot button to display the following screen.
Figure 108 Confirm Restart
Click OK.
Figure 109 Rebooting
Click OK again and wait for the system to restart. This takes up to two minutes.
7.7 AlmHis Backup Screen
Click Maintenance > AlmHis Backup in the navigation panel to open the following screen. Use
this screen to back up all alarm historical data on the MSC to your computer by clicking the Backup
button.
Figure 110 AlmHis Backup
To Next Page
Loading...
