Chapter 29 port Commands
Management Switch Card User’s Guide
786
29.8 port enable Command
Syntax:
port enable <slot-port>
This command turns on the specified subscriber port(s).
The following example turns on port 5 on the line card in slot 7.
29.9 port e1 Commands
Syntax:
port e1 alarmprof <slot-port> <profile>
This command sets the alarm profile used for the specified E1 port.
Syntax:
port e1 impedance <slot-port> 75|120
This command sets the impedance to 75 ohm (coaxial cabling) or 120 ohm (twisted-pair cabling)
for the specified E1 port.
Syntax:
port e1 timingsrc <slot-port> local|<port>
This command sets the time source for the selected E1 port. Use this command to have the
selected E1 port Either use the clock of the IMA line card (local) or use the clock of the connected
ADM device through an E1 line (1~8).
The following example sets the alarm profile, impedance and time source for E1 port 1 on slot 2 to
ATM-profile1, 120 ohm and local time source.
29.10 Enet Commands
This section covers how to configure settings for the Ethernet subscriber ports (on the ELC).
ras> port enable 7-5
ras> port e1 alarmprof 2-1 ATM-profile1
ras> port e1 impedance 2-1 120
ras> port e1 timingsrc 2-1 local
To Next Page
Loading...
