Chapter 32 show Commands
Management Switch Card User’s Guide
975
32.3.42 show vdsl linebandplan Command
Syntax:
show vdsl linebandplan <slot-port>
This command displays a VDSL line bandplan.
The following example shows bandplan details on the VDSL line connected to port 22 of the line
card in slot 2.
32.3.43 show vdsl linedata Command
Syntax:
show vdsl linedata <slot-port>
This command displays a VDSL port’s line bit allocation.
The following example shows VDSL line data on port 22 on the VDSL line card in slot 2.
32.3.44 show vdsl linegain Command
Syntax:
show vdsl linegain <slot-port>
This command displays the line gain of the active VDSL line. Line gain represents the signal input
required to compensate for losses in signal strength at different frequencies.
ras> show vdsl linebandplan 2-22
port 2-22, DSL line bandplan
bandplan US: [0, 63] [880, 1196] [1981, 2751]
bandplan DS: [0, 891] [1216, 1961] [2793, 3907]
ras> show vdsl linedata 2-22
slot-port=2-22, DSL line data
link = link_up
US0 carrier load: number of bits per symbol(tone)
--------- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
0- 15: 00 00 00 00 00 00 00 00 - 00 00 00 00 00 00 00 00
16- 31: 00 00 00 00 00 00 00 00 - 00 00 00 00 00 00 00 00
32- 47: 00 00 00 00 00 00 00 00 - 00 00 00 00 00 00 00 00
48- 63: 00 00 00 00 00 00 00 00 - 00 00 00 00 00 00 00 00
To Next Page
Loading...
