ZyXEL Communications MSC1000G - DHCP Relay Option 82 (Agent Information) Sub-Option 2 (Remote ID)

Chapter 19 acl Commands
Management Switch Card User’s Guide
660
The following figure shows an example. The asterisk (*) in front of a DHCP server address indicates
that it is the active DHCP server in the VLAN.
19.5 DHCP Relay Option 82 (Agent Information) Sub-
option 2 (Remote ID)
Use the following commands to configure the DHCP relay Option 82 (agent information) feature,
sub-option 2. This feature applies regardless of whether or not the DHCP relay is on.
19.5.1 Option 82 Sub-option 2 Enable Command
Syntax:
ras> acl dhcprelay82 suboption2 enable <vid>
where
This command turns on the DHCP relay agent information (Option 82, Sub-option 2) for the
specified VLAN.
19.5.2 Option 82 Sub-option 2 Disable Command
Syntax:
ras> acl dhcprelay82 suboption2 disable <vid>
where
This command turns off the DHCP relay agent information (Option 82, Sub-option 2) for the
specified VLAN.
ras> acl dhcprelay82 show
dhcp relay status: disable
dhcp relay mode: both
dhcp relay option82 info: [NULL]
server list:
server set: 1
index vid primary-server secondary-server
----- ----- ------------------ ------------------
1 3 192.168.1.10 (*)192.168.1.11
ras>
<vid> =
The ID of the VLAN to which to apply the setting.
<vid>=
The ID of the VLAN to which to apply the setting.