ZyXEL Communications MSC1000G - Profile Ratelimit Show Command

Chapter 30 profile Commands
Management Switch Card User’s Guide
888
The following creates an Ethernet subscriber line profile named test that limits ingress and egress
traffic to 12,800 Kbps.
30.15.4 profile ratelimit show Command
Syntax:
profile ratelimit show [<profile>]
This command displays the name(s) of the rate limit profile(s) you have configured. Specify a
profile to see it’s details.
30.16 profile shdsl Commands
Use the profile shdsl commands to configure SHDSL profiles.
30.16.1 profile shdsl set Command
Syntax:
profile shdsl set <profile> <min-rate> <max-rate>
[annexa|annexb 2wire|4wire|mpair4
[lp_off | lp_on_cur [curr_margin] | lp_on_wc [worst_margin]]]
where
ras> profile ratelimit set test 12800 12800
ras> profile ratelimit show
rate limit profile(s):
----------------------
1. DEFVAL
2. test
ras> profile ratelimit show DEFVAL
rate limit profile : DEFVAL
ingress rate : 0 kbps
egress rate : 0 kbps
<profile>
=
The descriptive name for the profile.
<min-rate>
=
The minimum transmission rate in Kbps (192~4096).
<max-rate>
=
The maximum transmission rate in Kbps. (192~4096)
annexa|annexb
=
The region setting, annexb is the default.
annexa: DSL over POTS.
annexb: DSL over ISDN.