Chapter 32 show Commands
Management Switch Card User’s Guide
945
The following example shows G.bond settings on the G.bond group named “gbondgroup1”
configured on the line card in slot 5. The ports 1 and 2 have set in the G.bond group, receiving and
transmitting rates, upstream (us) and downstream (ds) data rates for DSL lines on these ports are
zero.
32.3.11 show https Commands
Use the show https commands to display current HTTPS settings and statistics.
32.3.11.1 show https info Command
Syntax:
show https info
This command displays the HTTPS settings, statistics, and current sessions. The following figure
shows an example.
32.3.11.2 show https session Command
Syntax:
show https session
ras> show gbond 5 gbondgroup1
slot name mode rx(kbps) tx(kbps) us(kbps) ds(kbps)
port list
------------------------------------------------------------------------------
5 gbondgroup1 - 0 0 0 0
1,2
ras> show https info
Configuration
Version : SSLv3, TLSv1
Maximum session number: 64 sessions
Maximum cache number : 20480 caches
Cache timeout : 0 seconds
Support ciphers :
DHE-RSA-AES256-SHA DHE-DSS-AES256-SHA AES256-SHA EDH-RSA-DES-CBC3-SHA
EDH-DSS-DES-CBC3-SHA DES-CBC3-SHA DES-CBC3-MD5 DHE-RSA-AES128-SHA
DHE-DSS-AES128-SHA AES128-SHA DHE-DSS-RC4-SHA IDEA-CBC-SHA RC4-SHA
RC4-MD5 IDEA-CBC-MD5 RC2-CBC-MD5 RC4-MD5
Statistics:
Total connects : 0
Current connects : 0
Connects that finished: 0
Renegotiate requested : 0
Session cache items : 0
Session cache hits : 0
Session cache misses : 0
Session cache timeouts: 0
Sessions:
Remote IP Port Local IP Port SSL bytes Sock bytes
To Next Page
Loading...
